BONDiTTM
B-45, B-45TH, B-46, B-46TH, B-4681, B-4682, B-481, B-481TH,
B-482, B-482TH, B-52, B-521, B-536, B-536TH, B-575, B-575TH, B-755
Adhesive, Sealant, & Coating System
50 or 200 ml dual cartridge
• CAUTION!
Use proper safety procedures at all time while working with RELTEK
products.
• STORE
CARTRIDGE UPRIGHT (cartridge backplugs down and static mixer
end up) so that any entrained air bubbles migrate
to the static mixer end.
• WEAR
rubber gloves (such as Nitrile) and safety glasses.
• SURFACE
PREPARATION may be needed. Prepare surface by either sandblasting
or abrading with #100-120 grit sandpaper.
• WIPE
SUBSTRATE CLEAN with isopropyl alcohol (IPA) or Methyl Ethyl
Ketone (MEK) for rubber surfaces. Allow substrate surface
to dry thoroughly or evaporate.
• HOLDING CARTRIDGE static mixer end up, place appropriate
ratio plunger (*) into back end of cartridge, remove end plug on
front static mixer end of cartridge, hold both plunger and cartridge
vertically and push to “burp” cartridge, releasing
entrained air from cartridge before use. NOTE: BONDiT products
BONDiT B-52, B-521, B-536 all require 10:1 ratio plungers, the
others require a joint 1:1/2:1 plunger.
• WIPE cartridge clean with IPA after initial “burping”.
Attach 6” static mixing tube if available.
• Apply
adhesive to desired substrate. Always remember to push plunger
evenly and carefully as to not disrupt ratio of material
being mixed.
• GENTLY SQUEEZE material slowly and efficiently. After
needed material is applied, spread evenly over surface with an
acid brush, cut ¼” –1/2” at the end (for
cleanliness) until surface is evenly covered.
For application instructions for B series products in larger containers,
please click here.
Back to Product Selection Guide
Call (707)
284-8808 or email us reltek@reltekllc.com for advice on matching
BONDiT products for your specific application.